Every 12V build reaches a point where too many heavy cables need to meet in one place. Batteries, inverter, DC-DC charger, solar controller, winch feed, fuse block — and they all want the same positive and negative connection.

The usual outcome is four or five ring terminals stacked on one battery post, which is ugly, hard to service and a genuine resistance and heat problem. The Lynx Power In is the fix: a single pair of busbars with multiple M10 studs, so every cable gets its own clean connection.

Modular by design

The Lynx range bolts together. Power In joins to a Lynx Distributor for fused distribution, or to a Lynx Smart BMS, and the whole assembly becomes one continuous busbar with a tidy cover over it. You can start with this and add to it as the build grows, rather than rebuilding the whole centre.

M10 terminals

M10 studs take the lugs used on 2 AWG and larger cable — the sizes you need for an inverter or a serious DC-DC charger. This is not a small-gauge accessory bar; it is the main junction for the system.

Specifications

• Modular busbar, Lynx series
• M10 terminal studs
• Positive and negative busbars with insulating cover
• Bolts directly to other Lynx modules
• Weight: 5.73 lb
• Manufacturer part number: LYN020102010

Power In or Distributor?

Power In is a plain junction — connections only, no fusing. The Lynx Distributor adds fuse holders for each outgoing circuit. Most builds want both: Power In where the batteries and chargers meet, Distributor where the loads go out. Ask us and we will sketch out what your system needs.