The complete connector kit — two panels, two rear flaps and two wall sections — for joining two HD Nomadic 180 awnings into one continuous, closed-in setup.

Connector pieces join two HD Nomadic 180 awnings together. Run a 180 on each side of the vehicle and there is a gap where the two canopies meet. The connector slides into the same channel the awnings use and bridges that gap, so instead of two separate patches of shade you get continuous cover — up to 360 degrees around the vehicle or trailer.

This is the version that turns two awnings into a room rather than just more shade. The two wall sections close the connected spans in at the sides, the two rear flaps extend cover in toward the centre of the vehicle or trailer, and the zippers tie the whole run together.

It is the most expensive of the four connector options and the only one that does everything. If you are running two 180s on a trailer and want shelter all the way around rather than shade in patches, this is the one.

You need two 180 awnings for this to do anything. It is not a wall, it is not an awning, and it does nothing on its own or on a single awning. OVS specifies the two awnings mounted about 59 inches apart, base to base, on 55 inch crossbars. Each connector panel is 60.5 inches wide.

Not sure whether your two awnings are spaced right for this? Send us a photo of the rack and we will work it out with you before you order.