A single connector panel for joining two HD Nomadic 180 awnings — the plainest version, and the cheapest way to close the gap between them.

Connector pieces join two HD Nomadic 180 awnings together. Run a 180 on each side of the vehicle and there is a gap where the two canopies meet. The connector slides into the same channel the awnings use and bridges that gap, so instead of two separate patches of shade you get continuous cover — up to 360 degrees around the vehicle or trailer.

This one is the bare panel: no zipper, no rear flap, no wall section. It bridges one junction between the two awnings and nothing more. If you want the connected section to close in at the sides as well, the version with the zipper and wall section does that.

One panel closes one gap. Two 180 awnings meet at two points, so the two-piece set is what takes you to full wrap-around coverage.

You need two 180 awnings for this to do anything. It is not a wall, it is not an awning, and it does nothing on its own or on a single awning. OVS specifies the two awnings mounted about 59 inches apart, base to base, on 55 inch crossbars. Each connector panel is 60.5 inches wide.

Not sure whether your two awnings are spaced right for this? Send us a photo of the rack and we will work it out with you before you order.